Rogue Magazine News 6 Tips for Making Mittens from a Sewing Pattern

6 Tips for Making Mittens from a Sewing Pattern

6 Tips for Making Mittens from a Sewing Pattern

Mittens are the type of clothing people wear to protect themselves from cold. Materials that can be used are fur, wool, and leather. This type of glove covers the four fingers together, but the thumb is separate. These thermal insulators are available for different categories for babies, ladies, and gentlemen, and others are customized for professionals, such as oven mittens.

A sewing pattern is a set of instructions that give step-by-step instructions on making mittens out of fabric. You can trace the guide, cut out or trace it on fiber. In addition, you can modify it further to different shapes and sizes. There is a level of know-how you need to get to make a good mitten glove.

1- Get the Right Body Measurements

It is fundamental to ensure the body measurement has no errors. The reason is that the patterns come in different dimensions. Failure to have the correct length details may result in having a completely different product from your expectations. Therefore, ascertain that you have used a tape measure that is flexible to avoid disappointments.

2- Set the Seam Allowance

This allowance helps to maintain the elasticity of the mitten. It determines how loose or firm the mitten will be on the wrist. A zigzag stitch is preferable since you can set the short or wide snitch, which the machine can reverse if necessary.

3- Get the Instructions First

Directions given on the pattern sheet make it possible to have a quality end product. Guidelines such as the type of fabric and suggestions on how to cut the layout are the basics you need before making the mitten. Breaking your project into small manageable moves will save you from disappointments.

4- Keep Wrist Elastic Taut While Hand Sewing

Here, you can use a piece of cardboard inserted inside the wrist to keep it tight. A factor to consider is the mitten size that you are making. Ascertain that the mitten measurements are longer than that of the board to protect clothing from tearing when withdrawing the board. This tool will prevent the hangs or drapes that make the mitten look ugly and not serve the intended purpose.

5- Avoid Fluffy Lining by Stitching The Mitten From The Outside

When using blanket fiber, unfinished linings are likely to occur when the stitches are done inside. Hence, the mitten loses the beauty that one is looking forward to as they are visible. Therefore, pushing the needle from the outside of the mitten to the inside will eradicate this fuzzy lining. In addition, the fluffy lining is likely to cause a grip on the wrist, causing an uncomfortable effect since part of the clothing is pulled to the exterior.

6- Mark Your Pattern Pieces on the Garment

The marks identify where to place each piece while assembling. These marks put them on the side, which is the interior of the mitten. The markings must be of a pencil to make it easier to erase in case of any adjustment, such as the seam allowance.

Leave a Reply

Your email address will not be published. Required fields are marked *